Currently driver's side is very dim and passenger side is out again and vehicle cannot be driven at night. I've had this done 3 times since September 2020. One thing that will shorten the life of these bulbs is touching the bulb before installation, as oil from your fingers causes the glass to crack. Change chevy malibu headlight without removing bumper parts. Create an account to follow your favorite communities and start taking part in conversations. Driver side just started going out, but never replaced harness, think previous damage just caught up with me. 4157NA Turn Signal Bulb.
This was done to be safe as it is difficult and time consuming to replace. And each time they charge $200. On our vehicle, we remember that the measurement was 28 inches for our axis point. I am a single mom and cannot afford to continuously pay $180 to have bulbs replaced. It is almost like their is a loose wire somewhere. Change chevy malibu headlight without removing bumper pull. You're going to notice they come all the way across, and, of course, there's also going to be some push clips. Insert Bumper Side Over Bracket. Headlights repeatedly go out, even after changing the low beam lights almost every month.
The low-beam headlights keep burning out. I decided to register this complaint after finding a website where I went to try to figure out what was going on. Bolt closer to the wheel well and another a few inches in towards the front. The vehicle was taken to van Chevrolet (100 NW vivion rd, kansas city, mo 64118, 816-527-8564) to be repaired. Already, test the new headlight bulb(s) before continuing the re-assembly. Now, if you look right here, you can see there's a little slot, and if you look on the backside of the headlamp assembly right down there, there's an area that you're going to slide it on to. I have a 2010 chevy Malibu and the passenger headlight keeps going out. NFL NBA Megan Anderson Atlanta Hawks Los Angeles Lakers Boston Celtics Arsenal F. Change chevy malibu headlight without removing bumpers. C. Philadelphia 76ers Premier League UFC. Replaced them both the. All the other lights on that side work fine. A year later, still blowing bulbs....
It's uncontrollable, also very unsafe for who ever is in the vehicle. Loom to the rear of the headlight housing. We'll do the same on the other side. My car has just over 70, 000 miles on it. Sometimes the light will go out and back on when moving over a bumpy road. With this in mind, please consider the climate we live in today. The drivers side low beam is out again as of 2 days ago. Pull Out Plastic Fastener. My 2008 Chevrolet Malibu has the most annoying problem I've ever encountered in any vehicle which I have owned.
Last Monday the check engine light came on when the transmission was slipping m. The the transmission would no longer shift and the solenoid is stuck open while driving home from work. I've replaced low beam headlight bulbs 4 times (3 on passenger side) the past 13 months; the high beams 3 times (2 on passenger side). Within a year I have had to have the headlight bulbs in my 2010 chevi Malibu replaced 7 times. Exceeding customers' expectations, our team of passionate auto enthusiasts are here to help. Next insert the side of the bumper over the black plastic bracket by the wheel well. I have to take it to a mechanic shop because the front bumper has to be removed. I can not drive with one headlight or none. Pull off the black plastic bracket above the headlight. Animals and Pets Anime Art Cars and Motor Vehicles Crafts and DIY Culture, Race, and Ethnicity Ethics and Philosophy Fashion Food and Drink History Hobbies Law Learning and Education Military Movies Music Place Podcasts and Streamers Politics Programming Reading, Writing, and Literature Religion and Spirituality Science Tabletop Games Technology Travel. Carefully slide this out, and then we need to disconnect the assembly itself. There'll be a push clip right here, and then on the other side of this, there's another one there. If you come right here, you can squeeze this little tab. Push in a new # 4157NA (or 5702NAK) amber colored light bulb straight into the socket.
Line up the black plastic wheel well liner with the holes in the bumper cover and re-insert the Xmas tree fasteners. Luckily no accidents, but have been pulled over twice because of the issue. Insert Peg Into Hole.