This can cause wear and tear on the trigger mechanism and reduce its effectiveness. Consumer Item Depth. Disassemble it by removing the cap and the nozzle. If still the mop does not spray after refilling the bottle and charging the batteries, then check if the batteries are fully inserted or not. Follow this straightforward guide to redact Swiffer wet jet warranty in PDF format online free of charge: Register and log in. A pair of wires runs up the inside of the handle to the switch. As we said, check your cleaning solution bottle before installing it into the vacuum reservoir. There's the perfect Swiffer WetJet solution for any cleaning need! I recently purchased a Swiffer WetJet and when I went to use it, it is not spraying. I am very happy with this Swiffer wet jet mop and so thankful I have no more wringing out of and cloth mop. Why Is My Swiffer WetJet Not Spraying? So I guess for some reason sometimes for it to work, you have to take the batteries out and put them back in.
I am disabled but still want to help around the house. The Swiffer WetJet is a mop system with a two-nozzle sprayer, a cleaning pad and a scrub strip. Replace the scrubbing strip if it is dirty. Two wires connect the pump to the battery pack, attached with a pair of battery clips. There are a few common issues that could make it stop working. I vacuum before mopping and now I now have to walk around and pick up the pieces that have shed on the floors when I'm done. Occasionally, these motors get corroded from the water and chemicals used by the jet. The batteries are the power source that provides energy to the motor and trigger of the WetJet. If you do not want to get wet and dirty, you can also use a pin or a toothpick to unclog the spray nozzle of a Swiffer WetJet. Common Causes Of Swiffer Wet Jet Not Spraying. Now go into the pump assembly from the top and unscrew the two screws that hold the pump to the housing. Financing Details: MILITARY STAR promotions subject to credit approval.
Did I do something wrong and is there any way to fix this? I do not know if it turning on and not working but be sure the batteries are inserted correctly. DocHub User Ratings on G2. And then you have to press the spray button about 20 times. Separate the two halves of the cover. Dunk the cap in hot water to soften the plastic, twist it off, and then clip off the little locking tabs with a pair of nail clippers. Container Type||box|. First, start by removing the solution bottle and reinserting it. Unfortunately, sometimes it won't spray. Changing the batteries magically brings it back to life! Take the bottle out and you'll see a place that says OPEN. Or you just purchased and trying to put it together. I have a Swiffer Wet Jet CE.
Try using a pin to check the nozzle to make sure it is open so the liquids can pass through. Remove the screws that hold the front panel with a screwdriver. Maybe they are programmed to just last that long? First I cleaned the end where the cleaner squirts out (it was slightly clogged) and then I changed the batteries. The Swiffer WetJet is a better option for deep cleaning since you can spray as much cleaning solution as needed to deal with a specific mess.
I replaced my batteries today and it still didn't work for a minute and then all of a sudden when I kept pressing the spray button, it started spraying. I followed the tips on ThriftyFun for corroded contacts, exhausted batteries, etc. I hold the button and push it down, but as soon as I release the button it pops out and doesn't spray. 0:03 0:35 How to Unclog a Swiffer WetJet Nozzle - YouTube YouTube Start of suggested clip End of suggested clip Now what you need to do is take your water hose. What type of driver tool does it take to remove the cover to the pump motor? Line up the sticky strips to the corresponding strips on the bottom of your Swiffer, making sure that the rough strip on the face of the pad is towards the back of the mop head. Standard account terms apply to non-promotional purchases. Remove the two screws on each side of the hole where the solution bottle sits. There are two battery clips that attach the pump to the battery pack. Then I checked the old batteries and they were fine. FREQUENTLY ASKED QUESTIONS. Gently insert a toothpick into the hole on the sprayer nozzle to break up any dirt that could have gotten trapped inside.
For best end results on your floor, use with Swiffer WetJet mopping pads. Non-Military Star Card purchases valued less than $49 will incur a $4. This will move the warm vinegar solution through the sprayer hoses and break up any dirt clogging them. I was so very frustrated by this, then I found out what was wrong. When separating the 2 halves of the cover, you need to squeeze the smaller half to release the tabs inside. In this post, we have tried to discuss all possible reasons that can be a barrier to the spray. First, rise off the jets with hot water and stick a pin up into each jet.
A toolbox will help address plenty of problems with a vacuum or mop. Pads do not stick, wet or dry. We have covered everything from checking the trigger, solution bottle, nozzle, battery, and motor to tips on how to prevent these problems from happening in the future and address common questions. To keep the wires in tack go to the handgrip and remove the screws. Step 2: Remove the Rest of the Handle. We have also guided you on the easy way of fixing these issues. The two nozzles are secured by molded-in plastic clips; the easiest way to get them out is to grip the dark purple plastic just outside the nozzle and bend it down, then slip the nozzle out. By Richard from Stanardsville, VA. My machine is new, it is the first time I'm using it and it is only squirting out of one side.
Can you return Swiffer? Take a look at that little door on the newer models behind which you place the batteries. It takes 4 AA batteries. Refill pads won't stick! Is the cardboard removed from the canister area? You'll hear a click when the solution is installed correctly. I would appreciate if you can send me all kinds of coupons. If the spray is weak or does not work at all, it's likely that the batteries are dead and need to be replaced. Replace the cap, shake it vigorously to combine the ingredients, and place the bottle back in the machine as usual. The mop is much easier to work on with the handle off.