Going back into the shop tomorrow, 30 September. Just enough to keep it from moving freely. The contact stated that when the ignition switch was turned into the on position, the vehicle would make an igniting noise but would not start. G. Sprayed white lithium grease inside new shift handle, and triggered forward button on handle several times. If it cranks, you have a working ignition lock cylinder. Rusted– A key that is rusted can get stuck in the ignition system easily. If it's less than 12 volts, charge or replace the battery. Key Stuck in Ignition Causes: Chevy Colorado. Car keys are sensitive to any form of imperfection. An excellent example of such a lubricant is WD-40. After the pass lock reset, it took several attempts for the vehicle to restart. I'm a Chevy man all the way but I am very disappointed about this problem.
Have gotten stuck a couple of times with this. Does anyone know who to contact to report this? Hi Guys, had same problem with my 2015 Colorado and took to dealer today. I have a feeling its a BS "safety" switch in the shifter that's the problem. The family uncovered a YouTube video (and you can do the same) that outlines a streamlined Passlock reset procedure that worked for them. Even you can do it in your garage. If there's anything that you'll like to add, please leave a comment below. You're likely asking 'why is my car key stuck in the ignition if you cannot pull it out.
Conclusion: Colorado Key Stuck. Yes, it's a pain in the ass. I had the same problem and got it fixed early this week. The manufacturer was notified of the failure several times. You can replace the ignition switch on a Chevy Colorado by following the steps given below.
I have given solutions to all these problems so you can get in your Chevy Colorado and get going without having your fingers crossed every time you crank it up. There may be a manual shifter lock release as well on the shifter console. If you do massage the key out, go ahead and throw it away. Forum Statistics241. 2019 Canyon, 20, 000 miles. Has that change helped those that have had it done??? Seems like Colorado's have a problem.
Key stuck in the ignition and the dealer is charging me $450. There are several different ways to go about getting a key Unstuck from your vehicle's ignition. Jiggle the key and the steering wheel back and forth while depressing the brake pedal. I cant just run in quickly to do what I need to do. Restarted the truck several times, put it in park.. and after third or fourth time it worked.
If correcting this problem doesn't warrant a GM recall maybe a class action lawsuit is in order. It has been seen that 2004 and 2005 Chevy Colorados have this ignition switch issue a whole lot more than any other model. The following are several of the most common reasons that a key gets stuck in a vehicle's ignition cylinder. I said then you keep replacing shit until you figure it out!! I purchased it last June with 17, 000 miles, and about a week ago, it started acting up. You likely have a failing ignition lock that needs replacement, or your immobilizer has integrated with the ignition switch and requires a reprogram after replacing the unit. I believe its in the shifter console. Q: How do you test an ignition lock cylinder?
It was fix by gm for $385 ignition switch. Found out today that it will cost $400 out of warranty. The meter reading should be around 12.
Therefore, the situation is not as dire as it could be. Not in my Colorado, but I have experienced this in my Buick. This happened on the Chevrolet Malibu years ago. More Potential Problems AND Their Solutions. The other reason I always replace the entire part is because it seems wasteful to purchase the entire assembly and only use that small piece. The car is in accessory mode. If your car battery is discharged, it can prevent you from getting the key. Who's Online 36 Members, 0 Anonymous, 1, 546 Guests (See full list). Today I had to go in & out of park & neutral, letting the truck roll forward & trying the key a few times before I could remove it. Same problem as all the others.