Shall be of mahogany with two doors each with spring catch. About 800 Patrol Torpedo boats were built before and during World War II. Bohmfalk spent six years searching for a PT boat before finding PT-728 near Toronto. Access hatch blind scoop over engine room, as well as through special low-down vents over living quarters (see sec. Elco makes several different models with inboard propulsion systems. Historic WWII PT Boat for Sale. Some notes about Tru-Color Paint: Tru-Color Paint is an Acrylic 'hot' paint formula with a combination of Acetone and other media for its base. All joints shall be closely fitted, and properly landed, to obviate as far as practicable, circulation of gasoline. Spare parts will 30 be acquired under separate contract.
Deck hatches shall be cast aluminum throughout of raised gasketed type with special and improved hardware. Pipe railstops for 40 mm. Reclassified District Patrol Craft YP-110, 14 October 1941. A fore and aft cabin top stiffener each side of the center line shall be shaped to form an overhead handrail. Ww2 pt boats for sale replica. Heat exchanger assembly. 6 drums of ammunition shall be fitted with felt bearer strips and hinged covers.
Through special ventilator located above water closet located in deck, same type as described for crew's lavatory. And other special locations, where siding shall be increased to 1. inch. PT boats for sale $1.2M Price Dropped New 2022- WW2 PT Boats. We have included these in locations close to where they are found in the text surrounded by asterisks and in italic to separate them from the text ***** text *****. Cruise Speed: 20 Knots. The construction and fitting out, shall be corrected by and at the expense of the contractor. To read - "Instrument, Electric measuring combustible - gas - indicating portable - Type A of BuShips AD Interim Spec 18 I 19 (BuShips ltr. Scuppers to deck at low point. After turret to have separate spray shield to height of limiting stop.
Power system, electrical distribution. Entire floor shall be carried on longitudinal sides by heavy cleat on side panels of day room, with parting strips, and designed to function as spreader for inboard supporting panels or chocks, for the wing fuel tanks. 2 Boat hooks 10 ft., ash. If you are around the New Orleans area and have some spare pocket change…. The work shall be of the highest quality and shall meet the approval of the Supervisor of Shipbuilding. The contractor shall furnish such samples of materials and information as to the quality thereof and the manner of using the same as may be required, and any assistance necessary in testing or handling materials for the purpose of inspection or test shall be furnished by, and at the expense of the contractor. The athwartships dimensions of the air intake scoop shall be at least 6 inches wider each side than the hatch cover, or approximately 50 inches over-all. Ww2 Pt Boat - Brazil. Whether you're looking for a family boat or a great investment, PT boats are a unique option that's sure to please.
An open arch to starboard shall provide entry to the main passage fore and aft in. Forward passageway to starboard of crew's lavatory. The Government undertakes to complete, with reasonable rapidity, the inspection of all work. Buying Used PT boat for sale craigslist. A drain flange with threaded cap to be placed on each side of sampson post and accessible from the after side of bulkhead. Fresh water system assembly. World war two pt boats. VENTILATION AND HEATING. Lower berths shall follow inboard edge of outboard girder, and shall parallel floor with. Principal dimensions.
Controls shall be located at bridge and engine room hatch on deck. Weakness of structure which may develop before, during, or after trial shall be made good by the contractor. In consideration of the size of vessels and type of construction, it shall be within the province of the Supervisor of Shipbuilding to approve the use of materials other than as specified herein, where such materials may be found more suitable, or where considered equally suitable and more available. LIFE RAILS AND STANCHIONS. Welded steel towing pad and eye, hot dipped, galvanized, shall be fastened to the stem with inside blocking and brackets as required, complete with bridle and release mechanism and pendant for high speed towing. At the contractor's risk. Scarphs shall be plain bevel. 1 24 volt D. Ww2 pt boats for sale online. C., 115 Volt A. electric stove, 3-burner, portable oven type. It will be a unique addition to your collection. Beams shall be of mahogany, sawn type, molded 6 inches and sided 1 1/8 inches throughout except at hatchways, etc., where beams are 1 3/8 inches. Photographs are, however, required for only one vessel of the class. Lazarette -flooring shall be of slatted type giving full access to all parts of.
The average engine is 330 horsepower. Shall be located forward of the bridge and reached therefrom by a door with fixed window and clamping dog handle bolted on inside. A stretcher handling door shall be cut in starboard aft bulkhead of the cabin trunk. Fuel tank installation and construction of tank compartment. When alterations to the above plans are approved, the Bureau shall be furnished with reproducible copy of such altered plans. Gun working circles, bridge floor, areas in way of towing and mooring bitts, as required by the Supervisor of Shipbuilding, shall be covered with "Dektred" or equal. By accepting a contract to which these specifications are applicable, the contractor recognizes and acknowledges his obligation to cooperate with the Government in the efforts of the latter to. 50-caliber Browning machine gun stations, and four tubes with Mark VIII torpedoes. The contractor shall. All fastenings securing fittings and hardware to hull below water line to be of monel. Of the nearly 400 small, fast, versatile wooden Patrol Torpedo boats which were built around WWII, only a handful survive to this day. Table top shall have rounded edges and low rails on all sides.