If your Kenmore washer isn't spinning clothes dry enough, there are a few things that could be causing the issue. Does anyone know what the capacitance is of any available or listed replacement for 3348058? If your washer is making a grinding noise during the wash cycle and the agitator turns freely then the drive coupling may be damaged. The drive belt is what turns the agitator and the spin cycle.
Attempt to manually turn the agitator. Related article: Kenmore Washer Only Works on Delicate Cycle. Diagnosing and repairing a faulty motor can involve a bit of technical expertise. If your cogs have any of the symptoms described above, you will need a set of replacement directional cogs. Agitator Coupler & Cap & Bolt. The original was 270 - 324 mfd, 110 vac. The drive belt will be connected to the drive motor and can be removed by disconnecting the clamps holding it in place. If your Kenmore washer is not spinning, there are a few potential causes. Here is a video to show you what to look for if your washer motor coupler is broken. We are going to discuss 3 common reasons why your Kenmore washing machine will only hum and not spin.
If the water flow is adequate, then check for any blockage in the water valve's filter. Washer drive block: If the washer drive block is loose or worn down you'll have to replace it. Once the back panel is removed, you will be able to see the drive belt. During your laundry, objects such as coins, pens, hair pins, and even socks can escape and clog the pump. Top Load Washer - Fills But Will Not Agitate. Here is a video to show you how to remove and replace washing machine agitator dogs. If the door is not properly latched, the door lock will not engage and the washer will not start. The tub bearing is located under the tub, on the back of the washer. With a few tools and the new rear drum bearing, you can replace the old one and get your Kenmore washer spinning properly again.
Feel free to use your appliance insurance if it's still valid. Why is my Kenmore washer only humming and not spinning? C28932790 (yes I'm in Canada). If no issues are found with the air dome hose, you may need a replacement water level switch. Could it be that this is another issue creeping up due to unbalanced load that happened month ago - I remember that the wire that snapped appeared a little burnt in the are - possibly because of touching the washer frame. Kenmore Washer won't spin, agitatel. If the washer is not agitating, you may need to reset your washer motor. Just because the washer isn't turning on doesn't mean it's broken beyond repair.
Before replacing the switch, first eliminate the air dome hose as the problem. The problem may also be due to bearing failure, in which case the pump has to be replaced. Washer Motor Burned Out: This may result in a buzzing noise depending on circumstances. You can usually find different washer parts you need online, so all you need is a free afternoon and an assistant to keep the coffee coming to get your DIY fix.
There are a number of factors that could cause a washer not to turn on right away. About 2 years ago is when it first started acting up - motor buzzing but not turning. We recommend that you hire a professional to do the job for you. If your washer doesn't agitate but spins, there are several part failures that can lead to this dilemma. Next, check the transmission for any signs of damage or wear. The part will need to be replaced to fix this problem. Make sure the Start/Stop or Pause button was not pushed or that the timer knob was not pushed in.