One is marked Interarms Alexandria Virginia and the other has the CZ marking behind the Interarms logo on the side of the action with Manchester England behind the Interarms marking. Your calguns friend and MLC brother, Apples. I've had very good accuracy using those loaded to factory specs. Last edited by W. Buchanan; 06-29-2020 at 9:42 AM.. # 29. Hollow Knight: Silksong. Interarms mark x date of manufacture.com. Now, I'm not sure I'd want to be hunting whitetail deer with a. 1x fired 6mm Rem, 6. Last edited by 200Apples; 06-28-2020 at 3:30 PM.. # 28. Even at opening time... on a Monday, yet. The heavier bullets travel more slowly, and tend to penetrate more deeply.
Will consider ammo in the above). 5 Creedmoor You Must Read. Went shooin' this mornin' at my most-local outdoor range (Angeles) and it was crowded! That is, they lacked the stripped clip guide and the groove in the left sidewall for thumb clearance.
I looked at the receiver, expecting to see a set of German or Argentine proofmarks. 76 NOTES: Accuracy is the average of three, five-shot groups fired from a sandbag bench-rest. Interarms mark x date of manufacture 20. And while it's no Timney or Jewel, the trigger is crisp and averaged 3 pounds, 10 ounces, with about 5 ounces of variation over five measurements with a Lyman digital trigger-pull gauge. Chris: now all you need is one of these!!! I'm using a Leupold 1-4X w/plex. As for a safety, a two-position side lever is mounted on the trigger and found in the same location as that of the popular Remington Model 700.
The Mauser Mark X was a relatively light rifle for the time, between 7½ and 8 pounds in the standard calibers. MAGAZINE CAPACITY 5 rounds BARREL 24 in. Since the Mark X is basically a standard Mauser-length action, it's happiest when chambered for cartridges of 7x57 length or more rather than the shortish. Also It seems to have a hair trigger that I plan to take into a gunsmith this spring. Leave your best wishes, won't you? INTERARMS, and Manchester, England stamped on it as well. Trust me: That is light in a. This was a giveaway price! It may be a Mark X Alaskan, which were chambered in either. Withworth .375 need help with finding manufacture. 1-6x or 1-8x LPVO scopes (nothing chinese). The MTM R-100 series ammo box will fit your loaded rounds. Honestly, I don't know what I (will) have here, save to say it is one hell of a value in a stout, well-made Mauser action and chambered in. It was classic in design. 62 Winchester 80-gr.
If you aren't using an electric powder dispenser, consider that as well, or at least an electronic scale & trickler. And, to be fair, a whole lot of importers were bringing in Mauser actions and rifles from FN, Yugoslavia … and who knows where else. You will also need the correct trimmer collet; Wilson part #CH-375HH. And the water, just like that, it swallerd up all muh gunz! I also had an Interarms PPK/S in. Start buying reloading components. 35 Whelen on one; not sure what I will do with the other one. They can still be had at reasonable prices. It might be "moderate" by the standards of the end of the 19th century, but make no mistake: It thumps you. I am often wrong, just never in doubt. 338 Federal, 7mm-08,.
I use an RCBS single stage press. But all things considered, the deep, lustrous blue is worth it. Mine, the Mark X Alaskan Magnum, (aka Whitworth Express) in.